Impulsa tu creatividad y tu producción!
Unit cost
GTQ 119.00
/roll
Wholesale discounts
Quantity
Discount
Price per unit
1-3
0%
GTQ 119.00
4-11
2%
GTQ 117.00
12-19
4%
GTQ 114.00
20+
6%
GTQ 112.00
Total Cost
GTQ 119.00
Amount
/roll
1
Specification:
Thickness: 24 mic
Base: PET
Adhesive: EVA
Width(mm): 300
Length(m): 200
Temperature: Normal:95~105℃
Roller pressure: 10-20Mpa
Speed: 8-20 m/min
Advantage:
• Environmental friendly: non-hazardous to health and safe to use as no toxic gases or volatile content is emitted. Safe in laminating process as no solvent based adhesive is used.
• High function: compared with other solvent lamination, our film is better in clarity and bonding. It's preventing lamination from being pressed, bubbled and shredding off easily. Matt thermal lamination film is good for spot UV and hot stamping.
• Easy handling: it is easy to operate once the required temperature is met and no special technique is required.
• Efficient and energy-saving: Production is reduced substantially as there is no film wastage, mixture of adhesive solvent,
and no UV heating lamp is required.
Applications: top-grade presswork, outdoor advertisement, non-drying adhesive, tags, electric cable, electronic products.
C laminating operation sequence：
1.open the heating switch,set the preheating temperature 80-90 degrees. Automatic film mulching.
2.Preheat temperature is reached， the temperature control green light will be bright， suggesting that you can press the operating switch to start laminating.
3.At the beginning of the paper put the film, immediately set the temperature to 120-140 degrees continuous film.
4.in a batch of film finishing task is completed before leaving a few sheets of paper， to close the heating switch, adjust the temperature to 0 degrees,until the film is completed.
5.After the film, with a piece of paper waste in the middle of the rubber roll,and then press the pause switch last shutdown.
Waring:
1.Preheat temperature not exceeding 90 degrees, if the temperature is too high,the machine is in a state of suspension, the film iseasy to shrink or melt.
2. In the preheating state，found that the panel temperature has been rising， green Light does not shine,is an abnormal phenomenon,should immediately turn off the power supply.
3.Machine in the high temperature continuous film state, do not suddenly stop,The correct way is to set the temperature to 80 degrees，continue to cover a few sheets of paper，and then suspended.